Segments and recording

Create segments, start recording, “Just Record”, pause, save, and auto-stop.

Segments

A segment is a route with a defined start and end.

Create one via Segments:

Enter a name (for example Home → Office)
Choose color/icon. Optionally create the reverse direction (for example Office → Home)
Set start and end points (search by place or pick on the map).

Plane segments can be created by searching airport codes and default to nautical units.

Segment editor with name, color, and endpoint pins — Create a segment: name, appearance, and source / destination pins.

Each recording is usually tied to a segment ID so history and race-together mode compare correctly.

Start recording

Tap the green Start button on the main toolbar.
Pick a segment whose start is near you, or another segment (or resume a paused session).
The session is armed until you actually move; elapsed shows --:-- until the first moving GPS signal.
The red Stop button ends, pauses, or discards. By default the run is saved after 7 seconds with no other action.

Start control and segment picker on the map — Start → pick a segment with a nearby start, or another one (or resume a paused session).

Just Record

Record without choosing a segment first — start without knowing the destination. When you finish you can keep the recording only, or quickly create a new segment (from the Just Record start point → the end point). This feature does not support “Flight Mode” — flight segments need planned start and end points.

Pause and limits

Pause stashes the in-progress session so you can continue later. Useful for rest stops / gas stations.
Free may auto-save unfinished runs after a time limit (45 minutes).

Save sheet with pause, save, and discard options — After Stop: save, pause for later, or discard.

Auto-stop at destination

Enable in Settings: when you stop / move slowly near the destination, recording ends and saves automatically. A spinning ring on the destination pin shows progress for auto-stop.